SMALL/MEDIUM/BIG STUBBORN DOGREMOTE TRAINING COLLARfor Two Dogs
Control Two Dogs Individually or Simultaneously
Vibration + 3-Level Shocks
E-328B Remote Control Training Collar User’s Manual
Thank you for choosing our product!
Please read this manual carefully before using the product.
Please do read the Cautions, for fear that unwanted results arise
from improper operation.
A. Preparation before using
1. Make sure that batteries are installed in the remote controller.
Press the remote-control button , the LED indicator light will
2. Checking the remote controller: Press the buttons on the remote
controller one by one and the indicator light will light. If the
indicator light doesn’t light or goes dim, change the batteries.
3.When the receiver vibrates , the power indicator light installed
in the receiver will light . If it doesn’t light or goes dim, it
means that the electricity of the battery is not enough , then you
should use the appropriative charger to charge it.
4.Checking the receiver: connect the static testing bulb with the
static poles, press the remote buttons 1,2,3,4,5,6” one by one ,
then the receiver will release static, you can hear a pa-pa” sound
from the receiver. When the testing bulb is connected with the
poles , it will light. Every button has its own static mode. There
are six different modes in all.
5. Press the little button in the middle of the remote controller ,
then the receiver will vibrate , which can be used to send the
master’s meaning allowing”.
6. The static and vibration of the receiver stand for the orders or
intention from the master. You should let the dog understand and
remember them by training it . After each successful check, you should let the pet know what
should be done and what should not be done. After a number of
trainings the pet will understand what you like and don’t like.
7. Adjust the length of the collar to fit the neck of the pet. The
proper tightness should be that you can insert a finger in between.
8. Prepare some socks for the dog as rewards for good deeds. This
will make better effect in the training.
B. Operational instructions:
1. Open the insert buckle of the collar and put the collar round
the neck of the pet. Adjust the tightness of collar that you can
insert a finger in between.
2. Most pets feel uncomfortable at first wearing the collar. Don’t
use the static function at that time until you are sure that the
pet has gotten used to the collar. The static function is used to
curb the improper deeds of the pet. Don’t use it casually or to
make fun of the pet.
3. You can call your dog soundlessly by Weak vibration” in a long
distance. You can also use the B-B” sound to convey your orders.
4. If you don’t use this product, take the battery out of the
remote control, so as to prolong the lifetime of the batteries.
5. There is a vibration sensor switch in the receiver , you just
need to put it alone, then the power of it will be turned off
C: How to change or charge the batteries:
1. The lithium battery i